[landarts]

Here is a picture of the retainer clip I found for the top of heater control at local hardware store. It has small tabs in the opening and when you press down it wedges against the metal shaft to hold it. After that I went through and cleaned and lubed everything that I could with a little 3M oil, should be good to go for a while. The lever that was broken was the middle lever, it is the one that has the switch arm attached to it. I believe that the switch started to cease up and by forcing the lever caused it to break.

Next up this weekend will be laying down a few coats of single stage Copper poly 522 on the rust repairs, and hopefully a few coats on the front and back bumper with single stage White 521. After the bumpers are cured I will be shooting the back side of each bumper with 3M undercoating.