The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

SCOTI · 01-17-2010, 09:44 PM

With the rear frame 'clip' welded (fixed) in place, we loosened up the front frame section that was held in place on 3" square tubing w/rachet straps @ the 4 cab mount corners.

I relocated the front frame section by removing the 3" square tubing & pulling the front rear back together again. I welded the splice to keep things square while I made the gusseting plate (fish plates).

01-17-2010, 09:44 PM	#15
SCOTI Registered User Join Date: Apr 2001 Location: DALLAS,TX Posts: 21,914	Re: Project: Recycle With the rear frame 'clip' welded (fixed) in place, we loosened up the front frame section that was held in place on 3" square tubing w/rachet straps @ the 4 cab mount corners. I relocated the front frame section by removing the 3" square tubing & pulling the front rear back together again. I welded the splice to keep things square while I made the gusseting plate (fish plates). Attached Images __________________ 67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... *Cubic inches is like Indiana Jones with a cheap pistol.* Last edited by SCOTI; 01-17-2010 at 09:45 PM.