Exhaust frame bracket

[Wgesnerjr]

I have an exhaust frame bracket on the driver side of my frame, in the rear by the leaf springs. Wanted to know if there was such a thing on the passenger side?


I know once the trucks went to catalytic converters, they were all single exhaust. Just wondered if earlier models had a bracket on the passenger side? If so I need to start looking for one for my eventual dual exhaust set up.

[mongocanfly]

My 81 had the same brackets but only on the drivers side..

[mongocanfly]

I went and looked in my spare parts scrap pile and found the one I cut off my frame..its made a little different from yours but your welcome to it if you want it..

[Wgesnerjr]

Originally Posted by mongocanfly

I went and looked in my spare parts scrap pile and found the one I cut off my frame..its made a little different from yours but your welcome to it if you want it..

Do you happen to remember which side you cut it off? If it's the passengers that might work for me. If so can you give me a measurement from center of the mounting holes? I'd like to see if it matches up with the holes in my frame.

Thanks

[mongocanfly]

Came from drivers side...2 3/16" center to center on holes..holes, are staggered about 5/8" if bracket hangs vertical...overall height is 9 1/2" from top to bottom..

[Mr.Chevy4x4]

Diesel trucks had them on both sides.

Mike

[Wgesnerjr]

Originally Posted by mongocanfly

Came from drivers side...2 3/16" center to center on holes..holes, are staggered about 5/8" if bracket hangs vertical...overall height is 9 1/2" from top to bottom..

Thanks Mongocanfly. After careful measuring, it looks like I could mount it but the angle would kick out the wrong way. Looks like I will definitely need a passenger side one. If not, the exhaust guy can make something but it will cost me a little extra.

In the meantime, I will look for a diesel in the Junk yard.