Cab Lights

[crewcabshorty]

I am wanting to put cab lights on my K 20 . Does anyone have a good plan on spacing , drilling , type of drill , wiring ?

[mongocanfly]

I replaced my factory lights with low profile smoked leds..the spacing on mine is 3 in the center and 1 on each outside ..1 light in center of cab and 6" to center of the light on either side..the outside 2 lights from the center light is 24" to the center of the outside 2 lights..only need a small drill bit for screws and a 1/4"-5/16" drill for the wires..i just used my cordless drill to drill the new holes...the wires run between the 2 cab roofs down the driver side pillar..

[100%Chevy]

Wednesday,I put a Lund visor on mine.
The factory light locations fit O.K.
The visor is a pos!
So,if you plan on a visor it's a good idea to use the factory location for the lights!
Now,I need to get the leds!
Already have them on the sides and rear lights.
Mongocanfly,do you have a source/part number for the ones you used?
Mike.

[crewcabshorty]

Thanks . I got the lights at Napa . They look just like the oem except the grounds '

[mongocanfly]

100chevy..I got them off ebay..can't remember who they came from but the fit is good..

[100%Chevy]

Thanks!
I'll go to E-Bay and begin filtering thru all the junk adds!
But,I'll find them!
Mike.

[83GMCK2500]

We just had a thread similar to this, did you happen to see it? Add Cab/Clearance Lights??

[mongocanfly]

100chevy..here ya go..http://www.ebay.com/itm/For-Chevy-5P...JWtT6T&vxp=mtr

[100%Chevy]

Thanks!
Actually pretty good price too.
Mike.

[mongocanfly]

Yeah I didn't like tne factory ones...they looked like big orange soup bowls..these hardly even show on my truck..here's a pic..

[DieselSJ]

Originally Posted by mongocanfly

Yeah I didn't like tne factory ones...they looked like big orange soup bowls..these hardly even show on my truck..here's a pic..

Did you replace the factory ones with those? I'd like to find something similar to those that would be a direct swap without drilling any new holes.