![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Revitalizing a 6T C10
![]() Join Date: Aug 2017
Location: Santa Barbara, CA
Posts: 209
|
Refurbishing Parking Brake (1960 C10)
Hello All,
I've got a 1960 C10 1/2 ton truck, and I am looking at trying to get the parking brake set up working again. I have the lever (in cab) and there is a cable going to the pivot(bell crank?) in the center of the frame (underneath the cab) but I don't have cables, and I think I am missing some parts on the wheel / break side to make it actually preform. I've only seen stuff listed for the 64-66 trucks, can anybody tell me what I may be needing, and point me towards the earlier (Eaton) parts? Or does anybody know what parts may be compatible? This is the drum that had a seal blow, Its got to go to the shop because I'm not doing this in the street, and pull the axles, so please excuse the brake fluid - I am hoping to get this all wrapped at the same time. Thanks, Keith These are pictures of the Passenger Rear brake drum - Overall ![]() Left side ![]() Right Side ![]() Top ![]() Bottom ![]()
__________________
1960 C-10 Apache- "Rusty the Redneck Reject"
1/2 Ton short bed step side. 350 crate motor, 3 speed manual (floor shifted) MKII - Buddy Buckets and Glass Packs 20+ year long term project in process Lots of Rust, more memories... Last edited by 60short; 09-16-2020 at 11:25 PM. |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|