MT WTB NL2 tank

[Getter-Done]

Originally Posted by jaybatta

Think it would hurt to make the spacers longer so that it didn’t rest on the bed cross supports? It’ll hang below the bed a bit more, but I’d think it won’t be too bad. I suppose that’s something I can play with when I get there.

My Grandpa always trained me to improve the design if necessary.

Leave it alone if it was Good.

I think it needs a washer on the top of the spacer that will fit in the bed rib.

Then the bed ribs need a thin(1/16 to 1/8 inch) rubber strip where it touches the tank.

The top washer and adding 1 below will have the top of the bolt mounted Ridged.

Then the rubber in-between the tank and bed will keep things from shifting and loosening.