Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
05-02-2022, 09:17 AM | #1 |
Registered User
Join Date: Jun 2012
Location: crosby, tx
Posts: 114
|
Adding cruise to a manual
Does anyone have a pic of the firewall of a standard, where the wiring would go into the cab for the cruise wiring? The hole used for the cruise wiring harness on a automatic is being used for the rod going into the back of the clutch master cylinder, so i cant find a way (properly) into the cab with the harness. Any help would be appreciated
Last edited by jwodahl; 05-02-2022 at 09:29 AM. |
05-03-2022, 12:45 PM | #2 |
Registered User
Join Date: May 2015
Location: Tukwila Washington
Posts: 372
|
Re: Adding cruise to a manual
Here’s a couple pictures of the 1990 k1500 manual with cruise control. The module is mounted above the clutch cylinder, you can see where the cruise wire goes to a hole to the right below that.
__________________
'47 Panel to '88 K2500 Frame Swap Mechanical Speedometer Drive Solution 1947.2 1 ton Chevy Panel 1955.2 Chevy 6700 Bus/RV 1990 Chevy K1500 |
05-04-2022, 04:04 AM | #3 |
Registered User
Join Date: Jun 2012
Location: crosby, tx
Posts: 114
|
Re: Adding cruise to a manual
Thanks.. mine doesnt even have a blanked out hole there, so now i know where to drill.. lol
|
Bookmarks |
|
|