The 1947 - Present Chevrolet & GMC Truck Message Board Network

Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech > 73-87


Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-17-2015, 10:03 PM   #1
Registered User
RebelSoldier's Avatar
Join Date: Jun 2013
Location: Southaven, MS
Posts: 29
my project

I finally dove in and pulled out the old 350 which leaked from everywhere, and had a cracked block. Didn't know that till I pulled it out. So far I have redone the suspension. Put CCP 2.5 inch drop spindles, upper, and lower control arms. New rotors and calipers. New inner and out tie rods. New pitman arm, and idler arm. Just pulled all the dash components so I can start putting in my painless performance wiring harness. Then I'll be able to finally put in my Chevrolet Performance 350/ 330 hp crate motor.
Attached Images
RebelSoldier is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 05:03 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
Copyright 1997-2022