tons of info needs to be extracted from this thread - The 1947 - Present Chevrolet & GMC Truck Message Board Network

bollybib · 05-13-2011, 01:54 PM

REMOVING THE BED (1 of 2)

So I bit the bullet and took the bed off yesterday, solo.

The eight holddown bolts came out cleanly, no spinners. I had a couple of minor load shifts on the way up, but by moving slowly and checking constantly, I got there safely. It took me about six hours for the lift. This job was a freebie, I had everything on hand.

*Things to watch for: slide the bed back a bit before lifting to avoid hitting the cab; load distribution and balance.

Name: 000_0013 8pct.jpg
Views: 275
Size: 69.0 KB

Name: 000_0013 8pct.jpg
Views: 275
Size: 69.0 KB

Name: 000_0014 8pct.jpg
Views: 265
Size: 66.3 KB

Name: 100_4650 8pct.jpg
Views: 252
Size: 62.0 KB

Name: 100_4654 8pct.jpg
Views: 255
Size: 67.6 KB

Name: 100_4655 8pct.jpg
Views: 248
Size: 71.4 KB

05-13-2011, 01:54 PM	#10
bollybib Registered User Join Date: Nov 2010 Location: Carlsbad, CA Posts: 1,584	Re: Jim's 1969 Custom/20 REMOVING THE BED (1 of 2) So I bit the bullet and took the bed off yesterday, solo. The eight holddown bolts came out cleanly, no spinners. I had a couple of minor load shifts on the way up, but by moving slowly and checking constantly, I got there safely. It took me about six hours for the lift. This job was a freebie, I had everything on hand. Things to watch for: slide the bed back a bit before lifting to avoid hitting the cab; load distribution and balance. __________________ - Jim -* My Daily Driver is a 1969 Chevrolet Custom/20 Fleetside 350/TH400/Eaton H052 4.10 and its Project thread is here http://67-72chevytrucks.com/vboard/s...d.php?t=456911



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.