|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-09-2023, 03:53 PM
|
#1 |
|
Registered User
Join Date: Jan 2009
Location: Burbank, CA
Posts: 3,584
|
Hydro-Boost installation
I am trying to install a Hydro-Boost unit to replace my break booster. I am trying to figure out how to properly adjust the push rod that goes in between the booster and the master cylinder. The end of the rod inside the Hydro-Boost looks like a an acorn nut. The rod that was inside my old booster sat a little less than .5 inches below the mounting surface.
|
|
|
| Bookmarks |
|
|
Threaded Mode