|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-02-2021, 11:57 PM
|
#1 |
|
Registered User
Join Date: Oct 2007
Location: Austin Arkansas
Posts: 250
|
Vintage air heater control valve placement
Any ideas on where to hide the heater control valve? Can you put underneath the dash in the lines?
__________________
OLDIRONRACING |
|
|
|
12-05-2021, 09:35 PM
|
#2 |
|
Registered User
Join Date: May 2018
Location: Prattville, AL
Posts: 590
|
Re: Vintage air heater control valve placement
I ran my heater lines along the top of the inner fender well behind where you put the fender bolts in. So I went ahead and mounted it where you wouldn't see it under the fender.
It really doesn't matter where you put it since it is just a valve. The intent is to cut off coolant flow so that the A/C doesn't have to work as hard to cool the cab.
__________________
-------------------------------------------------------- 1967 C10 "Snowball" (Currently in a million pieces down from a bazillion) 1989 Toyota DLX pickup "The Hulk" 2012 Jeep JKU "Crush" 1976 Chevy short bed with a 327 and 3 on the tree (Sold it to buy the Blazer) 1971 Chevy Blazer (Sold it) |
|
|
|
|
12-05-2021, 09:50 PM
|
#3 |
|
Registered User
 Join Date: Dec 2013
Location: Dunwoody,Ga
Posts: 443
|
Re: Vintage air heater control valve placement
Be carefull in mounting. I found out its driectional when I had heating problems.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
