|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-15-2022, 11:46 PM
|
#1 |
|
Registered User
Join Date: Apr 2021
Location: Bismarck
Posts: 9
|
60x frame motor mounts after cross member swap
So i have the cross member off a 78 switched over to my 60 SWB. Im having a hell of a time finding a motor mount package for my 283 that will work on this set up. Any suggestios?
|
|
|
|
05-15-2022, 11:59 PM
|
#2 |
|
Senior Member
 
Join Date: Mar 2016
Location: Sonora California
Posts: 264
|
Re: 60x frame motor mounts after cross member swap
I used 67 - 72 mounts on my 62 with a 63 x member.
|
|
|
|
|
05-16-2022, 09:47 AM
|
#3 | |
|
Senior Member
  
Join Date: Jan 2018
Location: Hickory Flat, GA
Posts: 4,421
|
Re: 60x frame motor mounts after cross member swap
Quote:
__________________
Christian Carpenter 1963 C10 - Frankentruck 283, 3 speed with overdrive Overdrive wiring here1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson |
|
|
|
|
|
05-16-2022, 01:43 PM
|
#4 |
|
But Found Her 25yrs Later!
Join Date: Oct 2010
Location: Oregon City, Oregon
Posts: 10,468
|
Re: 60x frame motor mounts after cross member swap
On your 60-62 frame, you can use 67-72 V8 mounts.
Or if you use 63-66 mounts, you'll have to use a 1/2 inch spacer between the top rail of the frame to the underside of the top portion of the motor mount stand/perch. Here's mine with 63-66 stands/perches. . Here's another post from another thread: http://67-72chevytrucks.com/vboard/s...69#post5427669
__________________
I lost my 65 - Found it 25 years later: http://67-72chevytrucks.com/vboard/s...d.php?t=426650 66 C20 Service Truck: http://67-72chevytrucks.com/vboard/s...d.php?t=428035 Last edited by LostMy65; 05-16-2022 at 01:59 PM. |
|
|
|
|
05-16-2022, 11:57 PM
|
#5 |
|
Registered User
Join Date: Jan 2017
Location: Derby Kansas
Posts: 357
|
Re: 60x frame motor mounts after cross member swap
On my 61 I used the square body perches and cut them down and welded a plate on top.
|
|
|
|
|
05-17-2022, 01:12 AM
|
#6 |
|
Senior Member
Join Date: Mar 2016
Location: Sonora California
Posts: 264
|
Re: 60x frame motor mounts after cross member swap
I used the V8 mounts. I had the 63-66 mounts and had a block on the top of the frame rail but didn't like it. Capn fab suggested the 67 - 72 mounts and they worked out great.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
