LMC side fill tank

[rws1012]

I bought this tank and have it installed in my 66 C10. There are 3 vent lines. How many vents do I need? LOL !!
How is the best way to terminate theses tubes?
LMC said they aren’t techs or mechanics.
I am ususing mechanical fuel pump on my 250 ci engine. All help appreciated
Posted via Mobile Device

[Arne]

Probably designed to accommodate fuel injection with various return and evap lines. For carb use, I'd merge them into a single vent hose.

[61hawk]

I capped off the big tube with a rubber vacuum cap. The other two equal sized lines were run to rear stake pockets with a rollover vent cap. If you feed the line down from the stake pocket top you can screw the cap in from the bottom and you'll never see them.

https://www.summitracing.com/parts/TNK-VVR

[rws1012]

Originally Posted by 61hawk

I capped off the big tube with a rubber vacuum cap. The other two equal sized lines were run to rear stake pockets with a rollover vent cap. If you feed the line down from the stake pocket top you can screw the cap in from the bottom and you'll never see them.

https://www.summitracing.com/parts/TNK-VVR

Thanks. I will check out both ideas . Bed is off the truck now . Replacing brake lines and fuel line also.
Posted via Mobile Device