What did you do to your truck today part IV

[roll_the_dice]

Originally Posted by raic65

Not today, but over the last few weeks.

• Installed LED license plate lights
• Installed a center mount LED reverse light
• Replaced lower ball joints and idler arm
• Retorqued the inner tie rod nuts
• Replaced the CPP steering gear box with a new unit
• Repaired/replaced the locating pins for the lower control arms
• Installed power windows
• Installed push button start
• Finally, had the truck realigned

Nice list! Do you have pics of your LED reverse light? I haven't decided how to do my reverse lights yet.

[raic65]

Originally Posted by roll_the_dice

Nice list! Do you have pics of your LED reverse light? I haven't decided how to do my reverse lights yet.

I'll try to take a picture tonight. It took me a while to figure out what to do because I liked the look of the rear without the factory reverse lights. It was rather simple though after I found the solution because you can't tell it's there until it's lit.

[roll_the_dice]

Originally Posted by raic65

I'll try to take a picture tonight. It took me a while to figure out what to do because I liked the look of the rear without the factory reverse lights. It was rather simple though after I found the solution because you can't tell it's there until it's lit.

Thanks much appreciated!

[raic65]

Originally Posted by roll_the_dice

Thanks much appreciated!

Here are some pictures. Hope they help. I bought the light through Amazon. It is a little pricey though. The led light mounts on license plate frame so you don't really see it unless you're looking for it.

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

[roll_the_dice]

Originally Posted by raic65

Here are some pictures. Hope they help. I bought the light through Amazon. It is a little pricey though. The led light mounts on license plate frame so you don't really see it unless you're looking for it.

Thanks, I was thinking of putting them near the license plate. So that might work for me as well. I appreciate it. Looks nice and clean.

[53Sparky]

I finished chopping the frame today.

[MT65]

Originally Posted by raic65

Here are some pictures. Hope they help. I bought the light through Amazon. It is a little pricey though. The led light mounts on license plate frame so you don't really see it unless you're looking for it.

https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

Liking that rear light.......

[raic65]

Originally Posted by MT65

Liking that rear light.......

Thanks MT65. I was trying for a stealthy look. Just wish I could have found something cheaper. It sure is bright though. Both my brothers made the mistake of looking at it when I put the truck in reverse.