|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-16-2021, 03:51 PM
|
#1 |
|
Registered User
Join Date: Jul 2008
Location: Eastern Oregon
Posts: 2,263
|
C/20 Master Cylinder Distribution Block ?
I have a old school hydraulic trailer brake controller spliced into the distribution block on my 71 C/20. Can anyone tell me the actual size of the outlets on the block itself. I need to plug the outlet on the block when I remove the controller because it’s starting to leak...thanks
__________________
71 C-20 07 Magnum RT AWD |
|
|
|
09-16-2021, 04:19 PM
|
#2 |
|
Senior Member
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,430
|
Re: C/20 Master Cylinder Distribution Block ?
Maybe not much help here, but typical SAE brake fitting thread sizes are:
3/8"-24 1/2"-20 9/16"-18 Less common is 7/16"-24.
__________________
Mike 1969 C10 LWB -- owned for 34 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 23 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
