|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-09-2009, 08:18 AM
|
#26 |
|
Registered User
Join Date: Feb 2001
Location: Wetumpka, Al, U.S.
Posts: 8,891
|
Re: Gonna start drag racing with my pulling engine...need assistance
I have an all aluminum one piece shaft!
__________________
Kevin Special Thanks to All who have helped on the TRUCK! My Pass Time Show http://s129.photobucket.com/albums/p...Chapter1-0.mp4 So Far my best Times are: Motor only: 6.44 1/8 @ 104.13 10.39 1/4 @ 125.83 Nitrous Times: 5.785 1/8 @ 118.65 with a 1.336 60ft 9.168 1/4 @ 142.58 with a 250 shot dead out of the hole! |
|
|
|
03-16-2010, 12:55 AM
|
#27 |
|
Registered User
Join Date: Dec 2006
Location: Trinidad, Colorado
Posts: 642
|
Re: Gonna start drag racing with my pulling engine...need assistance
Well....Its been a while since this post was started, but will actually start on this project this week.
Thanks again for all your responses, and I hope to get plenty more for all the new questions I will have as the project progresses. Nothing much has happened since last post, but will have frame sandblasted and painted in about two weeks. This will get me into the front end, and eventually rear suspension. Pics, and questions to follow....  A..........
__________________
69' 3/4 4X4 470ci BBC 700 HP....  D60/14bolt 205/465 http://profile.myspace.com/index.cfm...ndid=127691959 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
