|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-26-2018, 04:12 PM
|
#1 |
|
Registered User
Join Date: May 2017
Location: TX <--> MI
Posts: 279
|
NP205 Rear Output Shaft Seal
Hey guys, I'm replacing the rear output shaft seal on my NP205. I can't get the old one out. I've been trying to pry it out with a screw driver and it's not really budging, just bending the metal. I was winding if anyone had any tips or tricks on how to get it out without a seal puller. Worst case scenario I can pull the whole cover off, but I'm trying to avoid that option since I don't have a gasket for it and I don't have much time to work on the truck so I'm trying to get it done now lol.
Any advice is appreciated. Thanks
__________________
1978 GMC K25 1984 Chevy Scottsdale K10 built 350 4"lift - SOLD |
|
|
|
04-26-2018, 06:44 PM
|
#2 |
|
Registered User
Join Date: May 2017
Location: TX <--> MI
Posts: 279
|
Re: NP205 Rear Output Shaft Seal
I ended up just taking the housing off and pressed the seal out and the new one in. And ordered a new gasket from Off-road Design. The old seal was really in there!
__________________
1978 GMC K25 1984 Chevy Scottsdale K10 built 350 4"lift - SOLD |
|
|
|
|
04-26-2018, 10:14 PM
|
#3 |
|
Registered User
Join Date: Dec 2011
Location: Yuma Arizona
Posts: 1,525
|
Re: NP205 Rear Output Shaft Seal
Go to Home Depot and get one of those paint can lid openers that have the hook on the end. These work great for pulling seals.
|
|
|
|
|
04-27-2018, 07:25 AM
|
#4 | |
|
Registered User
Join Date: May 2017
Location: TX <--> MI
Posts: 279
|
Re: NP205 Rear Output Shaft Seal
Quote:
__________________
1978 GMC K25 1984 Chevy Scottsdale K10 built 350 4"lift - SOLD |
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
