Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffener
 

Choppin Block front crossmember for 63-72 C10. Includes main crossmember, tubular A-Arms, 73-87 balljoints, LS motor mounts, power rack and pinion steering rack and steering rack hardware, splined front sway bar, KYB shocks, shock brackets, Unisteer 2 joint steering shaft. No bags included.
Sold

Porterbuilt Rear Dropmember for 63-72 C10. Trailing arms and outside mounted bags. Comes with tubular trailing arms, notch bridge with outside mounted bags, bolt in step notches, KYB shocks, Firestone sleeve bags, bag mounts, lower shock mount bar and panhard bar.

Sold

63-72 Porterbuilt Inner Frame Stiffener for 2 piece driveshaft.

Sold

All parts only used for mockup.

Also have the swb frame rails that these parts were mounted on.

$200 for frame rails.

Please check my build thread for more pics.

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

ttt

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

Choppin Block front kit sold locally pending pickup.

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

I have some interest in the frame stiffener. My truck won't lay frame, just a mild notch. Do you happen to know if it would work with a one piece shaft in that application? Next question do you have an idea of what shipping would be to 36502?

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

It should work with a 1 piece driveshaft as well. I can measure the driveshaft opening if you want to know how much room there is top to bottom line of the driveshaft loop. I quoted another member $1,150 shipped in my other thread in the 67-72 parts board and will do the same for you if you want it.

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

If you don't mind getting that measurement I would appreciate it, to be sure though I'll try contacting porterbuilt tomorrow to see if they have an opinion. In the meantime if you sell it I understand.

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

You would have 5 3/8” from the top bar to the bottom bar in the center and 5” on each side. This is the inside diameter for driveshaft clearance. Sorry I wasn’t able to get you the measurement sooner, I was on the road all day yeasterday and didn’t get back until late.

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

Unfortunately it's going to be too short an opening for me. Thanks for the effort though and good luck with the sale!

Re: Choppin Block front crossmember/ Porterbuilt Rear Dropmember & Inner Frame Stiffe
 

No problem, the inner frame stiffener and the rear Dropmember sold locally today.