[JRANGER]

Well did a few things on the workshop to get it ready for plywood next week. Simple stuff like additional cement anchor screws and adding an inside corner 2x4 to connect inner plywood/drywall to.

Then on to the truck....Went and go some fastener for the door panels but was out of luck so i could only install one door panel and order the other fastener set. Had to modify the window cranks to make them fit but i got them to...Dont like how they hold on so im adding holes to these stupid cranks to make them more solid otherwise they just wobble a bit...stupid stupid design

Also whats up with aftermarket door lock pins? 1/2" of screw and bam...your done...So now i have a 1/4" of screw showing at the bottom when unlocked? WTF!!!?!!! Now im going to have to cut off a 1/2" of that lock piece to make them fit nicely sheesh....Garbage