Miscellaneous things done this weekend. My rear calipers are freshened up with new slider boots, new pads, and paint. The rear brake line on the axle is bent up and installed.
I also started to play with the fuel system. That started by installing my sending unit/pump assembly. I think putting this together with the SUR&R nylon line kit is going to be a snap! I found an OEM fuel filter that uses 3/8" push connect fittings, that way finding a replacement and replacing it will be easy. Basically, using the supplied adapters at the fuel pump and push connect fittings running the lines should be easy....unless I decide to complicate it by adding some lengths of steel line in there. Actually running the lines will wait until I have the cab off, but it's motivating to see how easy it can be.
Fuel needs to go from here:
Through this:
And up to here (and back for the return trip):
Fastened down here and there with these:
