After removing the Radiator support, I was able to lower the body all the way onto the frame !!
-
-
I think I am good with how the rear of the body is sitting. The rear cross-section (where the gate mounts to) it laying perfectly on the chassis. Drill some holes and add a body mount ... done.
-
-
-
-
-
-
Full, uncut Spring shown here. Once the weight of the wood floors, all three rows of seats, fuel tank, etc., I think the preload height should be right on !!!
-
-
-
-
Glad that floor modification will not be that extreme ... Kids will have only a small hump to climb over ....
-
-