[tjsblazer]

Mike, one more question on your fuel tank neck swap. I took my new and old tank to the repair shop to swap necks as you did. The tank is probably from the same manufacturer as yours. It was a galvanized metal. Around the neck area where they had fastened it they had sprayed some grey paint on it.
I guess the new tank has the neck Brazed on where as the originals are just Soldered. The tank shop says they will have to heat the new tank around the braze fairly hot to remove it and are worried about warping. Is this how your tank removed the new neck, just by heating it up to remove the braze? Was there any issues with yours?
Thanks for any insight.

BTW, I followed your steps for fastening the front ball joints and knuckles. All good first time around. Thanks very much.