Re: tjs 72 Blazer Build
I've made headway on some of the wiring. I am using an American Autowire upgrade harness set for this truck which is a nice way to go if you are doing anything beyond stock. It comes with 6 additional built in circuits, 3 battery and 3 ignition. The downside is other than at the fuse panel you have to temporary route, crimp pretty much every terminal, put together the connections and then loom back the wires. It isn't hard, just tedious. I've gotten most of the under dash done, I looming it in factory style vinyl wrap. I have the rear harnesses cut to lengths and terminals on. I'm have to remove it yet and loom it and install the connections. Then it will be done. I haven't started on the Engine room and Front lighting yet. I have to buy a Heater harness. This kit just uses the stock one which I didn't realize and mine was in rough shape. A few progress pics from today.
Last edited by tjsblazer; 08-23-2016 at 09:39 PM.
|