Quote:
Originally Posted by reaper71
Ok, just went and looked at mine in my shop.
step #1. Measure up from floor to bottom of pedal from a (factory unit) or daily driver for reference and and sit in the seat and try out the height for comfort.
#2. if this all checks out, using masking tape on firewall mark all holes and drill the 3/8 holes for either the booster studs or bolts (like mine with No booster) and the large hole for the booster rod or pushrod for master.
#3. slide booster through 3/8 holes and bolt the pedal mount to the studs followed by master.
Or use 4 3/8 button head cap screws through firewall and bolt the pedal mount to these bolts then bolt the master to the firewall.
In total for NO booster you will have 6 3/8 holes 4 for the mount and 2 for the master.
Using booster only 4 3/8 holes for the mount.
Hope this helps!
Mark...
|
Awesome! thank you, I owe you Mark. Especially going back out on a cold night like tonight. Hope to get to this over Christmas holidays.
And thanks for the description on the tie in with the column bracing. I will go for the same.