Quote:
Originally Posted by cericd
Does anyone know what length the upper and lower mounting bolts for the bracket should be? I notice LockDoc mentioned 5/16" in an earlier post so I assume that's the diameter.
Also, if anyone prefers the look of the lower profile Phillips head screw for the top of the bracket, I found something that might be of interest. By doing a little Googling and comparing images found against the ones in this thread, the most similar profile is something called a "Phillips Truss Head" machine screw. They look like this. The truss head screws have a wide, lower profile head. I do realize that the truss head screws don’t have the flat area where the Phillips “cross” is on the factory screws but the overall look is pretty close.
|
I can't really tell by the pictures on here if the head has a flat area or not. The machine screws in this eBay ad have a flat area but they are only 1/2" long. They must be available in different lengths though.
https://www.ebay.com/i/181966238511?chn=ps
LockDoc