Quote:
Originally Posted by Dwolfe
The worse part is making sure you get all the angles right im worried mine might be off cuz the cardboard flexs �� Any tips? I figure my point were each sloped piece meets is 110 so each piece needs to be 55 to get a flat level surface. Right? Also the rear seams to be higher than the rest of frame if so my back piece will
Be shorter. Attached some pics of the 4 link to guys!
|
Measure the angle of the joint using the flat sides of the notch.
As for the 4 link, the brackets look to be made so that the triangle comes together at the rear. You might need to build a bar over the top of the rear to get the necessary triangulation you need to keep it centered (I recommend you do not weld the tabs to the center section directly).