The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - PROJECT "Father/Son" C-20 Rolling Chassis Build

**ChiefRocka** · 09-15-2007, 09:58 AM

The inside plate wasn't fitting as I would like, so I marked and trimmed a bit to get it to fit nice and square.

I did it this way, rather than squeese the plates together with clamps and welding.

Because of this, I had to fill a gap in the frame. My mearsurement from the front of the notch to the back was consistant all the way thru.

Once capped, you wouldn't be able to notice, but I don't gop out like that

-

09-15-2007, 09:58 AM	#82
ChiefRocka Hollister, CA. Join Date: Sep 2006 Location: Hollister, Ca. Posts: 6,147	Re: PROJECT "Father/Son" C-20 Rolling Chassis Build The inside plate wasn't fitting as I would like, so I marked and trimmed a bit to get it to fit nice and square. I did it this way, rather than squeese the plates together with clamps and welding. Because of this, I had to fill a gap in the frame. My mearsurement from the front of the notch to the back was consistant all the way thru. Once capped, you wouldn't be able to notice, but I don't gop out like that - - - - __________________ John What the Heck is that ?? CURRENT BUILDS: 62 BurbMaster Other Builds: My '63 C-10,LWB,CC,BBW '06 HD StrAight Axle Swap Father/Son '67 C-20, LQ9,4L80,Bagged,8-Lugger !!Good Friend Richard's Build AMERICAN CUSTOMS & CLASSICS (831) 630-1965 www.ACCHOLLISTER.com ACC on FACEBOOK "Rest in Peace, Mom & Dad ... I will see you again someday!"