Re: Project No-buck!
today (so far) i cleaned out the bed making a run to the dump....then i began vacuuming out the bed. as i'm doing this, standing in the bed my foot nearly goes all the way through. So to get any real use out of the truck i need to replace the floor. how thick is the wood supposed to be? I'm hoping 3/4", then i could just get 2 sheets of 3/4" plywood and cut them into the proper sizes.
additionally, the poor condition of the bed floor is actually going to make it easier to cut it down to a short bed and save a lot of welding!
|