Quote:
Originally Posted by highwinger
I understand all but this step. I don't see the screws shown in the dwg. Pulling the window back is the part I was missing and caused me to break the glass.
|
The screws I'm talking about are not shown in the drawing. One would be about where the arrow with the "A" is only it is on the back edge of the door above the latch. The other two are at the bottom of that same channel. They may be under the door panel seal. (See arrows on pic below.)
Quote:
Originally Posted by highwinger
Also, what sealant is used in the "#2 sash asm lower"? I did notice this may be loose on the vent window.
|
If it is loose I would just use a little black silicone sealant on it.
Quote:
Originally Posted by highwinger
I'm getting there  it really seems doable. Whose gaskets did you use? |
I think he bought the complete wing window assemblies, not just the gaskets.
LockDoc