I didn't really like the weld I did on the bottom of my SFBD. It didn't look up to my standard but I didn't fell comfortable just grinding it smooth. So I came up with this:
and welded them to the frame:
Did three of them on each side. Should be solid as can be.
Then I didn't like the por15 on there. It was starting to peal in some areas (and rock hard in others). It seemed like if you hit it just right it would come off. So instead of worrying about it I stripped it all off and shot it with epoxy instead.
Going to toss the engine and trans back in. Going to change the trans mount a bit (because I don't feel like drilling that many holes). Then start on the rear.