OK.. so I made some progress... I had my bracket turned down to clear the interference with the rotor. I then trimmed the bracket to clear the caliper abutment.... now all I need is a piece (actually one top and one bottom) to connect my bracket to the caliper... I'm soooooooo close.... slip on 14" rotors and twin piston caliper that should fit inside a 17" Hummer H2 wheel.....
Bracket in place, front view ....
Back view...
Trimmed the bracket and shaved the spindle. Mounted rotor to check clearance....
Slid caliper in place on the rotor, back view....
Top view ....
Front view .....