|
Re: How to: Ruin a perfectly good C10
Spent a couple hours tearing the bed apart today, instead of just taking it off in one piece, as I'll have to raise the floor before re-installation. Had more broken and seized bolts than expected, since I just put this thing together a few years ago. Percentage-wise, not so bad as there are a LOT of bolts holding these beds on/together.
Super dirty underneath, so I'll pull it back off the stands and outside to clean it up before working on it any further. Gratuitous, not-so exciting pics:
__________________
-Chris
Instagram _elgringoloco_
'70 Short-Wide How to: Ruin a perfectly good C10
‘70 Blazer ConversionHow To: Ruin a Perfectly Good 4wd
'72 Highlander How To: Ruin a Perfectly Good K/5 (SOLD)
'72 Blazer 2WD How to: Ruin a perfectly good Blazer (SOLD)
'05 Yukon Daily Driven (not so stock) Yukon (SOLD)
‘07 Yukon Denali (daily)
Members met list: SCOTI, darkhorse970, 67cheby, 67cheby'sGirl, klmore, porterbuilt, n2billet, Fastrucken, classicchev, Col Clank, GSFMECH, HuggerCST, Spray-Bomb, BACKYARD88, 5150, fine69, fatbass, smbrouss70, 65StreetCruiser, GAc10boy
|