Re: NP 205 Rebuild and Info
I am stopped here for a bit, this is a picture of my rear output yoke. I am going to try to clean off the teeth marks and speedi-sleeve it. This would be why I had a bad leak at the rear output.
If all your yokes are good to go, The torque spec that I found is 150lbft for rear. The front of this case is 10 spine. I don't have a torque spec. 30 and 32 spline front output torque is 150lbft. I will be using new nuts on both and speedi-sleeves on both. Once I have the sleeves I will cover the repair here.
Last edited by jbclassix; 06-26-2013 at 12:43 AM.
|