Re: Engine mount question.
I would opt to hang the engine/trans in place, then see where the mounts need to bolt? You may also find that the Olds (steel bracket on top), may be different in height/spacing, than a chevy pc? If the mounts set onto the brackets & bolt through, but the spacing is off,you might opt to unbolt the brackets on the towers, & move them around a tad (just center & bubble level on the engine). You can then redrill the holes, or weld them down ? longhorn
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|