Project "SWISS CHEESE" the 68 Camaro

[nuke1]

First i have to say, i have way too much on my plate but if that is not enough here is another one!

So today a new little one folowed me home. This is a friends car, it has quite the story, I will start with that. My old shop foreman has always wanted a 68 Camaro, last january he bought on, online from Mishigan. The pics seemed ok, he knew it was a little bit of a project, but he was ok with that. Well he sends a friend down there to go get it, this friend knows nothin about cars. Strike one. Well he gets home and Mike drives it around a bit. It creaks and groans a little but he seems satisfied. So he finally decided that he will take the interior apart and go from there. BAD NEWS. you can see through everything, he pulls the engine and lifts the car off the ground, subframe falls off, rusted right out. The P.O told him he could just jump in it and drive it back. STRIKE TWO. Now Mike is frustrated and comes over to my side and talks to me. Rmember he is my boss. We decide it be better not to let anyone at work know i am doing this for him. So he disassembles the complete car. I go look at it and i am floored. It is GONE. beyond that infact, this is the worst case i HAVE EVER TAKEN ON. Anything for a friend. So we orderd every single part of sheetmetal that we can. As of now this is how it sits, later this week i will take the plasma to the rest of it and go from there. So for now i will let the pics speak for themselves. All i am doing to this car will be the sheetmetal work. not a show car, just a driver that we are trying to save.