|
12-28-2018, 11:52 AM
|
#1 |
|
Registered User
Join Date: Oct 2018
Location: Sioux center, IA
Posts: 81
|
Driveshaft yokes
Since I have had such good luck will try one more time everybody has been so helpful okay so I needed a length in my drive shaft inch and a half went and got a longer yolk from the salvage yard which will work but it has this round like vibration dampener attached to it. Question is should I use it and leave it on does it come off or not use it at all any information would be much appreciated I will try see if I can figure out how to attach a picture once again since I forgotten go figure.
|
|
|
|
12-28-2018, 02:13 PM
|
#2 |
|
Registered User
Join Date: Apr 2008
Location: Md
Posts: 2,451
|
Re: Driveshaft yokes
I don't see why not, if the Splines are the same? There is 1" or so space between back of the trans and yoke? U joints are the same? use it as is.
__________________
http://67-72chevytrucks.com/vboard/s...d.php?t=635605 |
|
|
|
|
12-29-2018, 03:10 AM
|
#3 |
|
Registered User
Join Date: Oct 2018
Location: Sioux center, IA
Posts: 81
|
Re: Driveshaft yokes
Rite on!!! This is why i dig this site.No bull chit answeres,or snide remarks.
Thanks, and yes ujoint is same dia..Ive just never seen this type of dampener on a yoke befor. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
