|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-16-2015, 01:38 AM
|
#1 |
|
Registered User
Join Date: Sep 2014
Location: BELGRADE MONTANA
Posts: 31
|
66 c10 5.3/4l60e swap mount question
I have been trying to research motor mount adapters and have not come to a conclusion on which to use. Is it just a trial and error thing on where to set the motor? I have seen many from forward sets and rearward sets. I am looking for some insight on what is the best option or if there is a way to know before I have to hang the motor in there to find out.
Thanks in advance! 
|
|
|
|
01-16-2015, 12:15 PM
|
#2 |
|
Registered User
Join Date: Nov 2014
Location: Alameda, CA
Posts: 877
|
Re: 66 c10 5.3/4l60e swap mount question
If there's enough room between the engine and the radiator, forward makes it a little easier to get to things on the back of the engine. Farther back moves the weight distribution back, improving handling and launches.
__________________
1973 C20, 350/350 |
|
|
|
|
01-16-2015, 04:13 PM
|
#3 |
|
1965 Chevy C10, 2005 4.8L/4l60
 
Join Date: Aug 2004
Location: DFW Texas
Posts: 8,539
|
Re: 66 c10 5.3/4l60e swap mount question
Look here..
http://67-72chevytrucks.com/vboard/s...d.php?t=413855 I used the POL Perches on my 65 and some plates with SBC mounts, later two provided by TurnKey motors. Good luck!
__________________
Clyde65 Rebuild of Clyde http://67-72chevytrucks.com/vboard/s...84#post8338184 69 Aristocrat Lo Liner build http://67-72chevytrucks.com/vboard/s...84#post7561684  support our troops! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
