[LockDoc]

-
I completed the S-10 install in my '67 with a 250 six cylinder a few years ago. It works great! I purchased the spacer plate and used the '85 Astro van 11" clutch disk. I didn't have to use the adapter ring in the bell housing locator hole, the SM420 bell housing was the right size for the S-10 front bearing retainer.

Here is where the shifter is in relation to the bench seat. I bent the shift lever straight up from where the sharp bend was and it worked pretty good. It isn't as close to the dash as it looks. The shifter on it now is off of a full size pickup 5 speed and it is too big to screw on the shaft and too long. I just slid it down over the shift lever so I could test drive it.

The yellow circle shows where the original shifter hole was and the new hole is about 8-1/4" back.

LockDoc