The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - LockDoc's "Low Budget", "Low Maintenance" Project Thread

**LockDoc** · 08-18-2022, 08:55 PM

-
Smooth cowl vent is blasted and primed. I didn't get it done until later this afternoon. I hate wearing that hood when it is so hot. Now I can start final fitting and welding in the filler piece.

I also did some planning on the drive by wire accelerator pedal. I am going to make an adapter bracket for it. I didn't take any pictures of it but the 2002/03 accelerator pedal is offset to the right so the bracket will have to move the mounting plate over to the left a couple of inches. I don't think it will be too bad to make but it will have to fit a couple of offsets in the firewall. I will work on that again tomorrow.

LockDoc

08-18-2022, 08:55 PM	#232
LockDoc The Older Generation Join Date: Aug 2006 Location: Montezuma, Iowa Posts: 25,332	Re: LockDoc's "Low Budget", "Low Maintenance" Project Thread - Smooth cowl vent is blasted and primed. I didn't get it done until later this afternoon. I hate wearing that hood when it is so hot. Now I can start final fitting and welding in the filler piece. I also did some planning on the drive by wire accelerator pedal. I am going to make an adapter bracket for it. I didn't take any pictures of it but the 2002/03 accelerator pedal is offset to the right so the bracket will have to move the mounting plate over to the left a couple of inches. I don't think it will be too bad to make but it will have to fit a couple of offsets in the firewall. I will work on that again tomorrow. LockDoc Attached Images __________________ Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 -