The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

no1udknow · 10-01-2014, 01:25 PM

Yesterday I finished welding the front section of the shortened bed. Today I intend on cutting the rear section on my lunch break. My boss saw a gap I had in the bed floor that was about 3/8" wide and tol me that there was no way I would be able to weld the seam shut there, and that I would need to cut the seam wider and weld in a filler piece...I had to prove him wrong

10-01-2014, 01:25 PM	#80
no1udknow Registered User Join Date: Jan 2014 Location: Sacramento,California Posts: 696	Re: 68 c10 2wd in Sacramento, CA Yesterday I finished welding the front section of the shortened bed. Today I intend on cutting the rear section on my lunch break. My boss saw a gap I had in the bed floor that was about 3/8" wide and tol me that there was no way I would be able to weld the seam shut there, and that I would need to cut the seam wider and weld in a filler piece...I had to prove him wrong __________________ Built not bought! My dad always tried to convince me HEI was pointless! Welding is a lot like sex, you don't have to be great with the rod as long as you thoroughly prep the surface and your good at grinding My build : 68 C10 Short Bed Conversion