|
05-30-2002, 10:36 AM
|
#1 |
|
Registered User
Join Date: Feb 2001
Location: Sturgeon Bay , WI USA
Posts: 375
|
ramhorns
Whats a good price for new corvette ramhorns? The local chevy dealer said $137 each. What did everone else pay for theirs?
|
|
|
|
05-30-2002, 12:10 PM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,714
|
GM performance parts has them for about $85. I paid $78 from Ecklers for mine, but I think they have gone up. The 62-63 driver's side was the cheapest. I bought two and whacked off the gen mounts with my horiz/vert band saw and then smoothed the corners of the cut with a 7" grinder.
__________________
44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax |
|
|
|
|
05-30-2002, 03:24 PM
|
#3 |
|
user # 2756
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
|
www.gmpartsdirect.com has them for $86 a piece. Cost me $203 with shipping. Ordered the left and right for a 62 vette.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs 1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX 1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears 1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now..... 1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone. 1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed. 1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
|
|
|
|
05-30-2002, 05:37 PM
|
#4 |
|
Registered User
Join Date: Feb 2001
Location: Sturgeon Bay , WI USA
Posts: 375
|
Thanks for the link. I think I would rather pay $86 than $137.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
