Henry - 1984 C10

[SCOTI]

Originally Posted by aggie91

N brushed silver dash and door panel trim installed. I started to notice that the dash pad does not fit to my liking. Not sure what I am going to do about it. Bought it about 3 years ago and it been in the truck since. Just not the fit/finish I want anymore. Its a Cheyenne Pick Up Parts replacement, but just not the best fit in this truck.

I should have taken the daily driver mats out before taking pictures...

Don't want to put you on the spot but would you care to elaborate on this? What is the issue/concern?

[aggie91]

Originally Posted by SCOTI

Don't want to put you on the spot but would you care to elaborate on this? What is the issue/concern?

I will see if I can get a few pictures of the areas of concern when the truck is back at the house. Its around the bezel area and the leading edge along the windshield are the main areas I don't like.

[aggie91]

Korbin works for Jonathan, the Founder and President of Sparc Industries in Tyler, TX. So today, Henry was the model for a photo shoot for a new product being offered by Sparc Industries. Korbin and Jonathan have been working on this new wheel for a little while and the first one is shown installed in Henry in the pictures below. HUGE thank you to Jonathan to ask us to use Henry for the photos of his new wheel. It is available in a machined finish as well as the black finish shown here. There are a couple of leather wrap colors available from them too.

Henry will be with Jonathan and Korbin at the GoodGuys event in Nashville, TN on May 28-30, 2021. If you are going to the event, go check them out and say howdy. My daughter graduates HS that weekend so, I am not able to attend.

www.sparc.industires

Introducing the SQUAREBODY steering wheel.


‼️www.sparc.industries‼️ Proudly Made In #tylertexas - #sparcindustries #steeringwheel #squarebody #squarebodynation #trucknation #c10club #easttexassquares #c10truck #c10 #squarebodysyndicate #squarebodychevy #chevyc10 #c10nation #cncmachined #cncmachining #instamachinist #americanmade #classictrucks #customtrucks #baggedtrucks #smallbusiness

[aggie91]

Originally Posted by SCOTI

Don't want to put you on the spot but would you care to elaborate on this? What is the issue/concern?

Scoti, Sorry this took so long to get the pictures. The top of the dash is wavy, dips down at the center speaker, high at the passenger defrost vent. There is also a bubble in the vinyl next to the center speaker. The fit on the driver side around the bezel is not great and the drop on the side does not come down far enough along the bezel I'm more disappointed in the waviness of the top surface as that is what is right in front of you sitting in the truck that both the passenger and the driver can see. Hope this helps...