Quote:
Originally Posted by Nodnarb76
I'm in need of this pedal for my Suburban LQ4 swap.
I'm a little intimidated swapping wires around. Is there a guide on how to move wires around on the connector? How do I get the wise out of the connector without damaging them? And then how do I reinstall them?
I'm pretty much done with my swap, and it drives great,but the pedal is way out of position. Hate to go screwing with my harness if everything is working, but the diesel pedal sounds like a good idea.
|
I think they use a paperclip to disengage the pin, but I'm not 100% sure. If you open the .pdf file and read through it, I think it describes how to remove the pins/wires. Just a NOTE, I've not used the pedal that is described in the .pdf file, I was just passing on the info that I found.